Hornby Single Home Signal (R171)
Hornby Single Home Signal (R171) Height: 121mm Manual Operation Only
There are 10 products.
Active filters
Hornby Single Home Signal (R171) Height: 121mm Manual Operation Only
Hornby Y Point (R8076)Hornby points are supplied for operation by hand. They may be converted to remote control electric operation by using a 'point motor'.
Hornby Right Hand Point (R8073) Hornby points are supplied for operation by hand. They may be converted to remote control electric operation by using a 'point motor'.
Hornby Roll of Underlay (R638)Length: Approx. 4880mm longDesigned to fit the width of single track with indentations to fit the sleepers. Strip is flexible to follow any straight or curved track, and is easily cut to make junctions at points and cross-overs.
Hornby Single Track Level Crossing (R645)Length: 168mmCrossing comes with traditional gates and alternative lifting booms. Road sections clip around any straight section of track (track not included).
Hornby Point Motor (R8014) Powerful solenoid point motor for new model Hornby points that have the sliding bar mechanism. May be mounted above or below the baseboard
Hornby On-Off Lever Switch (Green) (R047)Conventional on/off switch for R618 double-isolating track. Supplied with connecting wires.
Hornby Two-Way Lever Switch (Yellow) (R046)Designed to divert power from one circuit to another - eg. with R406 coloured light signals to switch from red to green and back again. It may also be used to switch power from one section of track to another and is the switch you use to operate turntable R070.
Hornby Pass Contact Switch (R044) Supplies the brief pulse of current that a point motor requires. Supplied with connecting wires.